Tank Sealer News

APPLY RUSTSEAL IN THIN COATS

Remember that RustSeal should be applied in THIN coats. Applying too heavily, will cause running and/or sagging on vertical surfaces, and possible bubbling on horizontal surfaces. As RustSeal cures, it releases a small amount of carbon dioxide. If allowed to “puddle”, the top of the RustSeal directly exposed to the ambient humidity in the air (the actual catalyst for RustSeal) will begin to "skin" over. This "skinning over" is much like that of chocolate pudding and blocks the release of the afore mentioned carbon dioxide causing bubbles. By applying thin coats, this film cures through and through all at once.

MORE TIPS & TRICKS

RustSeal Fix-It Guide: This guide helps you quickly identify the causes of and the recommended solutions for the most common issues that could occur for RustSeal.

Note: We would love for you to share your tips with us.
Email us (suggestions@kbs-coatings.com) with your tips.

A customer of ours recently sent us these pictures.  He has a rusty trailer and he wanted to stop rust and prevent rust.  He was so happy with the results that he had to share these pictures with us.

You can find complete instructions for RustSeal here: http://www.kbs-coatings.com/RustSeal-Information-and-Instructions_ep_38-1.html

You can also find the Fix-It Guide which will help you quickly identify the causes of and the recommended solutions for the most common issues that could occur with RustSeal here: http://www.kbs-coatings.com/fix-it-guide-rustseal.html

You can also find Instructional Videos here: http://www.kbs-coatings.com/KBS-Videos_ep_90-1.html

You can also find a Flow Chart for using the KBS 3 Step System here: http://www.kbs-coatings.com/Flow-Chart–RustSeal-on-Steel_ep_87-1.html